Monday 10th December
Today i started creating some scissors and because of the way the top of the shape is it took a while trying to get the top bit the way i wanted it to be but because i asked for some guidance on how to do it, one of my tutors Simon helped me out and showed me how to do it so i than started again and did the top bit the way i wanted to so it looked how i wanted it to. Then i carried on with the rest of my scissors and got to the bottom piece of it and then i still had a problem trying to create a sharp angled point at the bottom however i just used the cut face tool but that left a whole in the bottom which i didn't want to be there.
Thursday 13th December
Because i ended on Monday in a problem i decided to start up today and ask for some advice and how to solve this problem and i was told to auto merge the points together to create the point i want and then use the move tool to place it where i wanted it to be, so i did and it worked out fine for me.
Friday 14th December
My team member Ben asked me today to create a lift switch board for the level so that is what i was creating today however i am still completely unsure of how to UV anything so i needed Simon or Drew here for me and they are not the tutors in lesson today so i was unable to complete it, i completed the sculpting of the lift switch board, the only thing i haven't done is UV it.
No comments:
Post a Comment